Aggregate Functions
PostgreSQL 9.4.21 Documentation | |||
---|---|---|---|
Prev | Up | Chapter 2. The SQL Language | Next |
Like most other relational database products,
PostgreSQL
supports
aggregate functions
.
An aggregate function computes a single result from multiple input rows.
For example, there are aggregates to compute the
count
,
sum
,
avg
(average),
max
(maximum) and
min
(minimum) over a set of rows.
As an example, we can find the highest low-temperature reading anywhere with:
SELECT max(temp_lo) FROM weather;
max ----- 46 (1 row)
If we wanted to know what city (or cities) that reading occurred in, we might try:
SELECT city FROM weather WHERE temp_lo = max(temp_lo); WRONG
but this will not work since the aggregate
max
cannot be used in the
WHERE
clause. (This restriction exists because
the
WHERE
clause determines which rows will be
included in the aggregate calculation; so obviously it has to be evaluated
before aggregate functions are computed.)
However, as is often the case
the query can be restated to accomplish the desired result, here
by using a
subquery
:
SELECT city FROM weather WHERE temp_lo = (SELECT max(temp_lo) FROM weather);
city --------------- San Francisco (1 row)
This is OK because the subquery is an independent computation that computes its own aggregate separately from what is happening in the outer query.
Aggregates are also very useful in combination with GROUP BY clauses. For example, we can get the maximum low temperature observed in each city with:
SELECT city, max(temp_lo) FROM weather GROUP BY city;
city | max ---------------+----- Hayward | 37 San Francisco | 46 (2 rows)
which gives us one output row per city. Each aggregate result is computed over the table rows matching that city. We can filter these grouped rows using HAVING :
SELECT city, max(temp_lo) FROM weather GROUP BY city HAVING max(temp_lo) < 40;
city | max ---------+----- Hayward | 37 (1 row)
which gives us the same results for only the cities that have all temp_lo values below 40. Finally, if we only care about cities whose names begin with " S " , we might do:
SELECT city, max(temp_lo) FROM weather WHERE city LIKE 'S%'(1) GROUP BY city HAVING max(temp_lo) < 40;
- (1)
- The LIKE operator does pattern matching and is explained in Section 9.7 .
It is important to understand the interaction between aggregates and SQL 's WHERE and HAVING clauses. The fundamental difference between WHERE and HAVING is this: WHERE selects input rows before groups and aggregates are computed (thus, it controls which rows go into the aggregate computation), whereas HAVING selects group rows after groups and aggregates are computed. Thus, the WHERE clause must not contain aggregate functions; it makes no sense to try to use an aggregate to determine which rows will be inputs to the aggregates. On the other hand, the HAVING clause always contains aggregate functions. (Strictly speaking, you are allowed to write a HAVING clause that doesn't use aggregates, but it's seldom useful. The same condition could be used more efficiently at the WHERE stage.)
In the previous example, we can apply the city name restriction in WHERE , since it needs no aggregate. This is more efficient than adding the restriction to HAVING , because we avoid doing the grouping and aggregate calculations for all rows that fail the WHERE check.